Clip Mount+
(adapter USB C - MSTB)
General
Clip Mount+ consists of the clip mount for the 5G SENS which is attached to a housing which includes a magnet to connect to a cabinet, an adhesive strip to support the connection, and an connector board with 5 sockets: 1 x industrial socket (MSTB), 2x dc jack 5.5x2.1mm, and 2 x USB-C socket.
The MSTB in connection with the “KGG-MSTB - Open” cable allows connections between devices and the GPIO inputs of the 5G SENS.
The 5.5x2.1mm jacks are intended for power distribution: Option to use 5.5x2.1mm power supply to connect to one of the jacks. Option to connect up to 2 more Clip Mount+ with a power plug cable in a daisy chain.
The non-standard USB-C sockets allow to connect the 5G SENS to the adapter board. With this, the 5G SENS can be connected to power in addition to its battery. Further, the GPIO pins are connected to the adapter board via the USB-C socket to the MSTB socket.
Another option is to use a USB-C power supply instead of a 2.1mmx5.5 mm device.
This cable does not follow the USB C standard!
Specification
| DC jack | USB-C | MSTB socket |
Type | Connector, dc jack 5.5x2.1 mm | USB-C 3.2 Gen 2, male | MSTB 2,5/5 |
Material | Insulator: Cover: Center Pin: Terminal: Spring contact: | Steel Termination area: Under-plated: | copper, tin Plastic |
Color | black | silver | green |
Max. Current Input | 2400 mA |
Max. Voltage | 5 V |
Weight | 85g |
Part Number | Length | Width | Height |
|---|---|---|---|
AE710124 | 96mm | 65mm | 33mm |
Compliances
General
Product Marketing Name | Clip Mount+ |
|---|---|
Hardware Revision | 25-009-1.1 |
Manufacturer | exelonix GmbH www.exelonix.com |
The Clip Mount+ is not a medical device. That means the Clip Mount+ is not intended for a medical purpose, to be used directly on humans.
Markings
The figure below shows the labeling of the Clip Mount+.
Label item | Description |
|---|---|
CE | CE marking is a certification mark that indicates conformity with health, safety, and environmental protection standards for products sold within the European Economic Area |
QR code | The QR code contains the following information:
|
CE / RoHs / REACH
Hereby, exelonix GmbH declares that the USB C - MSTB is in compliance with directives 2011/65/EU. The full text of the EU declaration of conformity is available in the following document:
WEEE
Exelonix GmbH (WEEE Reg. No. DE46285380) fully endorses the environmental objectives of the WEEE. All electronic products must be collected and sent to approved operators for the safe disposal of electronic equipment.
The WEEE Directive (2012/19/EU) aims to reduce the amount of waste electrical and electronic equipment that ends up in landfills. Its primary purpose is the prevention of waste electrical and electronic equipment (WEEE) and requires the re-use, recycling and recovery of such waste, to reduce its disposal to landfill or incineration. All electrical and electronic waste must be stored, collected, treated, recycled and disposed of separately from other waste. Therefore, if you are intending to discard these at the end of their useful life, please contact your local re-seller for disposal. Local authorities will also provide information on the free disposal of electronic equipment.