This chapter describes the different instructions used to control the u-blox SARA-R410M modem.
This AT-commands reads the operator profiles available on the device.
19: Vodafone (used for Vodafone Germany only)
197: Vodafone-global-roaming (used for roaming scenarios)
> AT+UMNOPROF=,1 OK > AT+UMNOPROF=? +UMNOPROF: 0: SW default 1: SIM ICCID select 2: ATT 7.1 6: China Telecom 7.0 31: DT 7.0 8: Sprint 7.0 100: Standard Europe 7.0 4: Telstra 7.0 21: TELUS 7.0 5: TMO 7.0 19: Vodafone 7.0 3: Verizon 7.0 197: Vodafone-global-roaming 7.2 OK |
This AT-commands activate the Vodafone global roaming profile. Usually used for the initial attach of the device to a cell.
//activate the Vodafone global roaming profile > AT+UMNOPROF=197 OK //reboot the device > AT+CFUN=15 OK |
This AT-commands activate the Vodafone Germany profile. This should be used in Germany only. It results in a much faster initial attach. Usually only used for the initial attach of the device to a cell.
//Set the Vodafone profile > AT+UMNOPROF=19 OK //Module reboot for saving changed profile > AT+CFUN=15 OK |
This AT-commands performs a full E2E data transmission to the cloud. Please make sure that the proxy IP address (213.136.81.171) is whitelisted at the operators APN (Access Point Name).
// Start network registration > AT+CFUN=1 OK > AT+CEREG=2 OK // Wait till registered to network > AT+CEREG? +CEREG: 2,5,"AB7D","790066",9 OK // Open UDP socket > AT+USOCR=17 +USOCR: 0 OK // Transmit "Test" to Exelonix UDP proxy > AT+USOST=0,"213.136.85.114",9876,4,"Test" +USOST: 0,4 OK // Data indication (seems to be unreliable) +UUSORF=0,3 // Receive response data "400" > AT+USORF=0,3 +USORF: 0,"213.136.85.114",9876,3,"400" OK // Close socket > AT+USOCL=0 OK // Disable modem > AT+CFUN=0 |
This AT-commands configures the default LED operation
The status is indicated by LED:
RED: Device is powered on
GREEN: device is registered in the network
GREEN/RED alternating: device is registered in the network and roaming (this will be the usual pattern)
/ GPIO2, red LED: global LED enable > AT+UGPIOC=23,0,1 OK // GPIO1, green LED: Power, Attached > AT+UGPIOC=16,2 OK // Reset the device to make setting effective > AT+CFUN=15 OK |