Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 10 Next »

(Cable KGG-MSTB - open strand)

General

The KGG-MSTB - Open cable is an extension of the USB C - MSTB cable and allows access to each GPIO. In this way the GPIO lines can be mounted in screw terminals. An industrial connector is used for the connection to the USB C - MSTB cable

Specification

Plug A

Open Endings

Type

IC 2,5/ 5-ST-5,08

Wire end sleeve

Material

Plastic

-

Color

green

-

Compliances

General

Product Marketing Name

KGG-MSTB - Offen

Revision

?

Manufacturer

exelonix GmbH
Washingtonstraße 16/16a
01139 Dresden
Germany

The KGG-MSTB - Offen is not a medical device. That means the KGG-MSTB - Offen is not intended for a medical purpose, to be used directly on humans.

Markings

The figure below shows the labelling of the KGG-MSTB - Offen.

Label

Label item

Description 

Rev.

Formal structure: <Digits-Digits-Digits.DigitsLetter>
The letter at the end describes the hardware option,
e.g. which sensors are on board.

CE

CE marking is a certification mark that indicates conformity with health, safety, and environmental protection standards for products sold within the European Economic Area

QR code

The QR code contains the following information:

  • web address of manual

CE / RoHs / REACH

Hereby, exelonix GmbH declares KGG-MSTB - Offen is in compliance with directives 2014/53/EU, 2011/65/EU. The full text of the EU declaration of conformity is available in the following document:

WEEE

Exelonix GmbH (WEEE Reg. No. DE46285380) fully endorses the environmental objectives of the WEEE. All electronic products must be collected and sent to approved operators for the safe disposal of electronic equipment.

The WEEE Directive (2012/19/EU) aims to reduce the amount of waste electrical and electronic equipment that ends up in landfills. Its primary purpose is the prevention of waste electrical and electronic equipment (WEEE) and requires the re-use, recycling and recovery of such waste, to reduce its disposal to landfill or incineration. All electrical and electronic waste must be stored, collected, treated, recycled and disposed of separately from other waste. Therefore, if you are intending to discard these at the end of their useful life, please contact your local re-seller for disposal. Local authorities will also provide information on the free disposal of electronic equipment.

  • No labels