The following documentation describes how to configure the required applications
| Info |
|---|
Getestet auf Raspberry Pi4 mit Raspberry Pi OS (64-Bit und 32-Bit) von 04.07.2024 |
| Note |
|---|
Noch nicht getestet ob vor Konfiguration mit AT Commands notwendig |
…Step 1: Read which USB port Linux has indicated on the flash drive.
| Code Block |
|---|
pi@raspberrypi:~ $ nmcli device show GENERAL.DEVICE: ttyUSB2 GENERAL.TYPE: gsm GENERAL.HWADDR: (unknown) GENERAL.MTU: 1500 GENERAL.STATE: 100 (connected) |
…Step 2: Set up your mobile network by changing the APN address and USB port name to your own.
| Code Block |
|---|
sudo nmcli connection add type gsm ifname ttyUSB2 con-name mymodem apn vgesacetest.nb.iot sudo nmcliiot.de connection up id mymodem .autoconnect yes |
Step: 3: Restart operating system
| Code Block |
|---|
sudo reboot
|
Wait of AttachStep 4: Wait for connection
USB Connect LPWA lights up red continuously if no connection can be established. The LED lights up alternately red and green. A longer red light phase indicates that a connection is being established. If the LED lights up green for longer, the connection has been successfully established. Connection can take up to 15 minutes