...
| Version | Date | Changes |
|---|---|---|
| 1.0 | Initial Version | |
| 1.0.1 | Extending the description of the serial adapter board |
Components
The NB | DEV KIT hardware consists of two boards:
...
EX-EVL210 USB/RS232 serial adapter board
...
- Micro USB Connector
- Used to power the complete NB | DEV KIT
- UART interface to EX-COM210 via 5V Micro USB
- Must always be connected to power the device, even if USB UART connection is not used
- RS232 Connector
- UART interface to EX-COM210 via 12V RS232 serial port
- 3.3V UART Connector
- UART interface to EX-COM210 via 3.3V pins
- Pin U1: TX
- Pin U2: RX
- Pin U3: Ground
- UART interface to EX-COM210 via 3.3V pins
...
- Set jumper to select one of three available UART interfaces to be used
- Pin J1 and J2: Micro USB UART
- Pin J2 and J3: RS232 UART
- Pin J2 and J4: 3.3V UART
...
- Triggers a reset of the EX-COM210 board
...
UART Interface selection
The EVL210 has three serial UART interfaces, which can be used to interact with the EX-COM210 NB-IoT board:
Label | Connector type | Voltage level | Comments |
|---|---|---|---|
J102 | female screw terminals | 3.3V | pin mapping: U1 = TX, U2 = RX, U3 = GND |
J103 | micro USB connector | 5V | The micro USB connection is also the power supply, therefore it must always be connected (even if not used as UART). |
J104 | RS232 connector | 12V |
In order to the select the desired serial interface, the jumper on J101 has to be changed:
Interface | Connected jumper pins |
|---|---|
| screw terminals | J4 & J2 |
| mirco USB | J1 & J2 |
| RS232 | J3 & J2 |
Peripherals
The reset button triggers a hard reset of the EX-COM210 NB-IoT board. Any state of the microcontroller and the NB-IoT modem will be reset, therefore a (Re-)Attach is needed.
There are also three status LEDs:
- LED1 indicates the power status of the EX-COM210 board
- LED2 indicates if the microcontroller is updating its status; in normal situations the LED should blink every second
- LED3 : turned on if indicates if the NB-IoT modem is attached to a NB-IoT cell (LED on = attached, LED off = detached)
- LED4 : turned on indicates if a modem procedure (attach, transmit, receive, ...) is ongoing
The EX-COM210 NB-IoT communication board
...