...
Ensure proper EMC-shielding of the USB-Connection.
SIM Card Access
Unscrew the enclosure of side with the label.
...
Lift off the enclosure halve at the front of the USB connector and then pull in the direction of the USB connector.
...
Now you can see the SIM card holder and open its flaps by sliding them in the opposite direction from the USB connector. You are now able to put any 3FF SIM card in the holder.
...
To reassemble, go backwards.
Effects of mechanical shocks
If the stick falls vertically onto the USB connector, there is a possibility that the flap of the SIM card holder will open and the SIM card will fall out. A cover is offered for this case, which additionally blocks the mechanism of the SIM card holder and thus fulfills special stress requirements.
The SIM cover is placed as follows:
| Drawio | ||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Integration USB Connect 4G - XX
The maximum performance over all LTE bands results when the USB Connect 4G - XX is connected vertically to a PCB. There may be small metal parts 2 cm near the USB stick, but they must not occupy entire side surfaces. In any case, there must be no metal parts on the top of the USB Connects 4G - XX. The surroundings can be covered with plastic accordingly, which also promotes a distance of> 20 cm from the body. For use on a typical consumer host device, the USB Connect 4G - XX is not optimized. The device is strictly for industrial use/application and installed in industrial environment.
The command interface of the device is also protected with a password. For the password, contact the manufacturer. The stick cannot be controlled without the password. This is to ensure that the device is only used by customers who can guarantee a distance of minimum 20 cm from the body when using it.
This device is not intended for remote access via LTE. This also includes firmware updates and changes to the radio settings via LTE. If a firmware update is necessary, please contact the manufacturer.