...
Install the drivers for Windows/Linux operating system on your host device.→ https://www.telit.com/evkevb-drivers/
Plug in the USB Connect 4G into the USB Type A socket of the host device.
Make sure that the distance from your body to the USB Connect 4G is larger than 20 cm.
If the USB socket of the host device is active, the USB Connect 4G starts automatically.
Now you can identify the COM port of the USB Connect 4G - EU and send AT commands to unlock the AT command interface. For this, you need to send the following command (ask manufacturer for password):
Code Block AT#SECIFAUTH=XXXXXXXXXX
Power Down
| Note |
|---|
To avoid any damage to the USB device , the power supply must not be interrupted before the shutdown procedure has been fully carried out. |
...
Για να αποφευχθεί οποιαδήποτε ζημιά στη συσκευή USB, η τροφοδοσία ρεύματος δεν πρέπει να διακόπτεται πριν ολοκληρωθεί η διαδικασία τερματισμού λειτουργίας. |
Πρώτα ορίστε την ακόλουθη ρύθμιση μέσω της διεπαφής εντολών AT (π.χ. μέσω του ελεγκτή AT):
Code Block AT#GPIO=10,1,1
Now the command Τώρα η εντολή
Code Block AT#SHDN
can be sent to shut down the μπορεί να σταλεί για να τερματίσει τη λειτουργία USB Connect 4G.
After 15 sec you can safely disconnect the USB Connect 4G from the host device.
Operating
...
Μετά από 15 δευτερόλεπτα, μπορείτε να αποσυνδέσετε με ασφάλεια το USB Connect 4G από τη συσκευή υποδοχής.
Λειτουργικός
...
Συμμορφώσεις
...
Γενικός
| Note |
|---|
Please consult User ManualΠαρακαλούμε συμβουλευτείτε το Εγχειρίδιο χρήστη |
To ensure compliance with RF exposure guidelines the device must be used with a minimum of 20cm separation from the body. Failure to observe these instructions could result in your RF exposure exceeding the relevant guideline limits. The requirements for the location and the according limitations to locations with distance of minimum 20cm to the user are clearly indicated with the USB device. The device is strictly for industrial use/application and installed in industrial environment. This device is not intended for remote access via LTE. This also includes firmware updates and changes to the radio settings via LTE. If a firmware update is necessary, please contact the manufacturer.
...