Versions Compared

Old Version 5

changes.mady.by.user Thomas Möller

Saved on

compared with

New Version 6

changes.mady.by.user Thomas Möller

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

As already described, the stick contains the LE910C4-XX module from Telit. The compliance information statements for this module can be found at https://www.telit.com/m2m-iot-products/cellular-modules/standard-industrial-grade/xe910-family/#LE910Cx-downloads

USB Connect 4G - NF

ISED Certification

This device will be registered with Innovation, Science and Economic Development Canada under the following number:

IC: 5131A-LE910CxNF

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

  • This device may not cause interference;

  • This device must accept any interference, including interference that may cause undesired operation of the device.

FCC Certification

This device contains will be registered with the Federal Communications Commission under the following number:

Contains FCC ID: RI7LE910CXNF

  • No changes shall be made to the equipment without the manufacturer’s permission as this may void the user’s authority to operate the equipment. Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

  • This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

  • This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

PTCRB

The product manufactured by Exelonix GmbH is in compliance with PTCRB.

For further information you can visit this page : https://www.ptcrb.com/

USB Connect 4G - EU

CE Certification

Hereby, exelonix GmbH declares that the radio equipment type USB Connect 4G - EU is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.exelonix.com/de/

...

Exelonix GmbH fully endorses the environmental objectives of the WEEE. All electronic products must be collected and sent to approved operators for safe disposal of electronic equipment.

USB Connect 4G - AP

Australia

This device is in compliance with the Australian "Radiocommunications Act 1992" and, therefore, it is labeled according to the "Radiocommunications (Compliance labeling – Devices) Notice”.

Japan

This device is granted pursuant to the Japanese Radio Law (電波法).

This device should not be modified (otherwise the granted designation number will become invalid).